ath79: add support for ALFA Network Tube-2HQ

ALFA Network Tube-2HQ is a successor of the Tube-2H/P series (EOL) which
was based on the Atheros AR9331. The new version uses Qualcomm QCA9531.

Specifications:

- Qualcomm/Atheros QCA9531 v2
- 650/400/200 MHz (CPU/DDR/AHB)
- 64 or 128 MB of RAM (DDR2)
- 16+ MB of flash (SPI NOR)
- 1x 10/100 Mbps Ethernet with passive PoE input (24 V)
  (802.3at/af PoE support with optional module)
- 1T1R 2.4 GHz Wi-Fi with external PA (SE2623L, up to 27 dBm) and LNA
- 1x Type-N (male) antenna connector
- 6x LED (5x driven by GPIO)
- 1x button (reset)
- external h/w watchdog (EM6324QYSP5B, enabled by default)
- UART (4-pin, 2.00 mm pitch) header on PCB

Flash instruction:

You can use sysupgrade image directly in vendor firmware which is based
on LEDE/OpenWrt. Alternatively, you can use web recovery mode in U-Boot:

1. Configure PC with static IP 192.168.1.2/24.
2. Connect PC with one of RJ45 ports, press the reset button, power up
   device, wait for first blink of all LEDs (indicates network setup),
   then keep button for 3 following blinks and release it.
3. Open 192.168.1.1 address in your browser and upload sysupgrade image.

Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>
This commit is contained in:
Piotr Dymacz 2022-02-17 23:22:25 +01:00
parent 53ac6ee552
commit 131671bc54
4 changed files with 85 additions and 0 deletions

View File

@ -0,0 +1,65 @@
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
#include "qca9531_alfa-network_r36a.dtsi"
/ {
model = "ALFA Network Tube-2HQ";
compatible = "alfa-network,tube-2hq", "qca,qca9531";
aliases {
led-boot = &led_signal4;
led-failsafe = &led_signal4;
led-upgrade = &led_signal4;
};
leds {
compatible = "gpio-leds";
pinctrl-names = "default";
pinctrl-0 = <&enable_gpio4 &enable_gpio16>;
lan {
label = "blue:lan";
gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
};
led_signal4: signal4 {
label = "green:signal4";
gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
};
signal1 {
label = "red:signal1";
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
};
signal2 {
label = "orange:signal2";
gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
};
signal3 {
label = "green:signal3";
gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
};
};
};
&eth0 {
nvmem-cells = <&macaddr_art_1002>;
nvmem-cell-names = "mac-address";
mac-address-increment = <(-1)>;
};
&eth1 {
compatible = "syscon", "simple-mfd";
};
&usb0 {
status = "disabled";
};
&usb_phy {
status = "disabled";
};

View File

@ -48,6 +48,14 @@ alfa-network,r36a)
ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0" ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0"
ucidef_set_led_switch "wan" "WAN" "blue:wan" "switch0" "0x10" ucidef_set_led_switch "wan" "WAN" "blue:wan" "switch0" "0x10"
;; ;;
alfa-network,tube-2hq)
ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0"
ucidef_set_rssimon "wlan0" "200000" "1"
ucidef_set_led_rssi "signal1" "SIGNAL1" "red:signal1" "wlan0" "1" "100"
ucidef_set_led_rssi "signal2" "SIGNAL2" "orange:signal2" "wlan0" "25" "100"
ucidef_set_led_rssi "signal3" "SIGNAL3" "green:signal3" "wlan0" "50" "100"
ucidef_set_led_rssi "signal4" "SIGNAL4" "green:signal4" "wlan0" "75" "100"
;;
asus,rp-ac66) asus,rp-ac66)
ucidef_set_rssimon "wlan0" "200000" "1" ucidef_set_rssimon "wlan0" "200000" "1"
ucidef_set_rssimon "wlan1" "200000" "1" ucidef_set_rssimon "wlan1" "200000" "1"

View File

@ -13,6 +13,7 @@ ath79_setup_interfaces()
allnet,all-wap02860ac|\ allnet,all-wap02860ac|\
alfa-network,ap121f|\ alfa-network,ap121f|\
alfa-network,pi-wifi4|\ alfa-network,pi-wifi4|\
alfa-network,tube-2hq|\
arduino,yun|\ arduino,yun|\
aruba,ap-105|\ aruba,ap-105|\
asus,rp-ac66|\ asus,rp-ac66|\
@ -529,6 +530,7 @@ ath79_setup_macs()
alfa-network,n5q|\ alfa-network,n5q|\
alfa-network,pi-wifi4|\ alfa-network,pi-wifi4|\
alfa-network,r36a|\ alfa-network,r36a|\
alfa-network,tube-2hq|\
engenius,eap300-v2|\ engenius,eap300-v2|\
engenius,ens202ext-v1) engenius,ens202ext-v1)
label_mac=$(mtd_get_mac_binary art 0x1002) label_mac=$(mtd_get_mac_binary art 0x1002)

View File

@ -298,6 +298,16 @@ define Device/alfa-network_r36a
endef endef
TARGET_DEVICES += alfa-network_r36a TARGET_DEVICES += alfa-network_r36a
define Device/alfa-network_tube-2hq
SOC := qca9531
DEVICE_VENDOR := ALFA Network
DEVICE_MODEL := Tube-2HQ
DEVICE_PACKAGES := rssileds -swconfig
IMAGE_SIZE := 15872k
SUPPORTED_DEVICES += tube-2hq
endef
TARGET_DEVICES += alfa-network_tube-2hq
define Device/allnet_all-wap02860ac define Device/allnet_all-wap02860ac
$(Device/senao_loader_okli) $(Device/senao_loader_okli)
SOC := qca9558 SOC := qca9558