ath79: add support for ALFA Network AP121FE
The AP121FE is a slightly modified version of already supported AP121F model (added to ar71xx in0c6165d21aand to ath79 in334bbc5198). The differences in compare to AP121F: - no micro SD card reader - USB data lines are included in Type-A plug - USB bus switched to device/peripheral mode (permanently, in bootstrap) Other than that, specifications are the same: - Atheros AR9331 - 400/400/200 MHz (CPU/DDR/AHB) - 64 MB of RAM (DDR1) - 16 MB of flash (SPI NOR) - 1x 10/100 Mbps Ethernet - 1T1R 2.4 GHz Wi-Fi, up to 15 dBm - 1x IPEX/U.FL connector, internal PCB antenna - 3x LED, 1x button, 1x switch - 4-pin UART header on PCB (2 mm pitch) - USB 2.0 Type-A plug (power and data) Flash instruction (under U-Boot web recovery mode): 1. Configure PC with static IP 192.168.1.2/24. 2. Connect PC with RJ45 port, press the reset button, power up device, wait for first blink of all LEDs (indicates network setup), then keep button for 3 following blinks and release it. 3. Open 192.168.1.1 address in your browser and upload sysupgrade image. Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>
This commit is contained in:
Piotr Dymacz
parent
7f96cbd2a1
commit
66abd58196
|
|
@ -1,38 +1,11 @@
|
|||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "ar9331.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
#include "ar9331_alfa-network_ap121f.dtsi"
|
||||
|
||||
/ {
|
||||
model = "ALFA Network AP121F";
|
||||
compatible = "alfa-network,ap121f", "qca,ar9331";
|
||||
|
||||
aliases {
|
||||
label-mac-device = &wmac;
|
||||
led-boot = &led_vpn;
|
||||
led-failsafe = &led_vpn;
|
||||
led-upgrade = &led_vpn;
|
||||
serial0 = &uart;
|
||||
};
|
||||
|
||||
keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
reset {
|
||||
label = "reset";
|
||||
linux,code = <KEY_RESTART>;
|
||||
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
switch {
|
||||
label = "switch";
|
||||
linux,code = <BTN_0>;
|
||||
gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
};
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
|
|
@ -54,81 +27,6 @@
|
|||
};
|
||||
};
|
||||
|
||||
ð0 {
|
||||
status = "okay";
|
||||
|
||||
mtd-mac-address = <&art 0x0>;
|
||||
|
||||
gmac-config {
|
||||
device = <&gmac>;
|
||||
switch-phy-addr-swap = <0>;
|
||||
switch-phy-swap = <0>;
|
||||
};
|
||||
};
|
||||
|
||||
ð1 {
|
||||
status = "okay";
|
||||
|
||||
compatible = "syscon", "simple-mfd";
|
||||
};
|
||||
|
||||
&spi {
|
||||
status = "okay";
|
||||
|
||||
num-cs = <1>;
|
||||
|
||||
flash@0 {
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <50000000>;
|
||||
m25p,fast-read;
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x000000 0x030000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@30000 {
|
||||
label = "u-boot-env";
|
||||
reg = <0x030000 0x010000>;
|
||||
};
|
||||
|
||||
art: partition@40000 {
|
||||
label = "art";
|
||||
reg = <0x040000 0x010000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@50000 {
|
||||
compatible = "denx,uimage";
|
||||
label = "firmware";
|
||||
reg = <0x050000 0xfb0000>;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&uart {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&usb {
|
||||
status = "okay";
|
||||
dr_mode = "host";
|
||||
};
|
||||
|
||||
&usb_phy {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&wmac {
|
||||
status = "okay";
|
||||
|
||||
mtd-cal-data = <&art 0x1000>;
|
||||
};
|
||||
|
|
|
|||
112
target/linux/ath79/dts/ar9331_alfa-network_ap121f.dtsi
Normal file
112
target/linux/ath79/dts/ar9331_alfa-network_ap121f.dtsi
Normal file
|
|
@ -0,0 +1,112 @@
|
|||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "ar9331.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
|
||||
/ {
|
||||
aliases {
|
||||
label-mac-device = &wmac;
|
||||
led-boot = &led_vpn;
|
||||
led-failsafe = &led_vpn;
|
||||
led-upgrade = &led_vpn;
|
||||
serial0 = &uart;
|
||||
};
|
||||
|
||||
keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
reset {
|
||||
label = "reset";
|
||||
linux,code = <KEY_RESTART>;
|
||||
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
|
||||
switch {
|
||||
label = "switch";
|
||||
linux,code = <BTN_0>;
|
||||
gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
|
||||
debounce-interval = <60>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
ð0 {
|
||||
status = "okay";
|
||||
|
||||
mtd-mac-address = <&art 0x0>;
|
||||
|
||||
gmac-config {
|
||||
device = <&gmac>;
|
||||
switch-phy-addr-swap = <0>;
|
||||
switch-phy-swap = <0>;
|
||||
};
|
||||
};
|
||||
|
||||
ð1 {
|
||||
status = "okay";
|
||||
|
||||
compatible = "syscon", "simple-mfd";
|
||||
};
|
||||
|
||||
&spi {
|
||||
status = "okay";
|
||||
|
||||
num-cs = <1>;
|
||||
|
||||
flash@0 {
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <50000000>;
|
||||
m25p,fast-read;
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x000000 0x030000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@30000 {
|
||||
label = "u-boot-env";
|
||||
reg = <0x030000 0x010000>;
|
||||
};
|
||||
|
||||
art: partition@40000 {
|
||||
label = "art";
|
||||
reg = <0x040000 0x010000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@50000 {
|
||||
compatible = "denx,uimage";
|
||||
label = "firmware";
|
||||
reg = <0x050000 0xfb0000>;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&uart {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&usb {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&usb_phy {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&wmac {
|
||||
status = "okay";
|
||||
|
||||
mtd-cal-data = <&art 0x1000>;
|
||||
};
|
||||
32
target/linux/ath79/dts/ar9331_alfa-network_ap121fe.dts
Normal file
32
target/linux/ath79/dts/ar9331_alfa-network_ap121fe.dts
Normal file
|
|
@ -0,0 +1,32 @@
|
|||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "ar9331_alfa-network_ap121f.dtsi"
|
||||
|
||||
/ {
|
||||
model = "ALFA Network AP121FE";
|
||||
compatible = "alfa-network,ap121fe", "qca,ar9331";
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
lan {
|
||||
label = "ap121fe:green:lan";
|
||||
gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
led_vpn: vpn {
|
||||
label = "ap121fe:green:vpn";
|
||||
gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
wlan {
|
||||
label = "ap121fe:green:wlan";
|
||||
gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
|
||||
linux,default-trigger = "phy0tpt";
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&usb {
|
||||
dr_mode = "peripheral";
|
||||
};
|
||||
|
|
@ -13,6 +13,7 @@ case "$board" in
|
|||
ucidef_set_led_switch "wan" "WAN" "$boardname:orange:eth1" "switch0" "0x04"
|
||||
;;
|
||||
alfa-network,ap121f|\
|
||||
alfa-network,ap121fe|\
|
||||
avm,fritz450e)
|
||||
ucidef_set_led_netdev "lan" "LAN" "$boardname:green:lan" "eth0"
|
||||
;;
|
||||
|
|
|
|||
|
|
@ -75,6 +75,9 @@ ath79_setup_interfaces()
|
|||
winchannel,wb2000)
|
||||
ucidef_set_interface_lan "eth0"
|
||||
;;
|
||||
alfa-network,ap121fe)
|
||||
ucidef_set_interface_lan "eth0 usb0"
|
||||
;;
|
||||
avm,fritz4020|\
|
||||
pcs,cr3000|\
|
||||
tplink,archer-c58-v1|\
|
||||
|
|
@ -398,6 +401,7 @@ ath79_setup_macs()
|
|||
label_mac=$lan_mac
|
||||
;;
|
||||
alfa-network,ap121f|\
|
||||
alfa-network,ap121fe|\
|
||||
engenius,ens202ext-v1)
|
||||
label_mac=$(mtd_get_mac_binary art 0x1002)
|
||||
;;
|
||||
|
|
|
|||
|
|
@ -228,6 +228,15 @@ define Device/alfa-network_ap121f
|
|||
endef
|
||||
TARGET_DEVICES += alfa-network_ap121f
|
||||
|
||||
define Device/alfa-network_ap121fe
|
||||
SOC := ar9331
|
||||
DEVICE_VENDOR := ALFA Network
|
||||
DEVICE_MODEL := AP121FE
|
||||
DEVICE_PACKAGES := kmod-usb-chipidea2 kmod-usb-gadget-eth -swconfig
|
||||
IMAGE_SIZE := 16064k
|
||||
endef
|
||||
TARGET_DEVICES += alfa-network_ap121fe
|
||||
|
||||
define Device/allnet_all-wap02860ac
|
||||
SOC := qca9558
|
||||
DEVICE_VENDOR := ALLNET
|
||||
|
|
|
|||
Loading…
Reference in New Issue
Block a user