3e53eec589
Add support for SAMA7G5-EK board. Hardware: - SoC: SAMA7G5 - RAM: Aliance Memory AS4C256M16D3LC (4 Gbit DDR3L) - SD/MMC: 1 standard 4bit SD Card interface - USB: 1 Micro-AB host/device, 1 Type-A host, 1 Type-C host - CAN: 2 interfaces - Ethernet: 10/100 port, 1Gbps port - Wi-Fi/BT: 1 optional interface - Audio: 1 SPDIF RX port, 1 SPDIF TX port, 4 digital microphones - Camera: 1 RPi CSI camera interface - Debug: 1 J-Link-OB + CDC, 1 JTAG - LEDs: 1 RGB - Buttons: 4 push buttons - Expansions: 1 RPi Expansion connector, 2 mikroBUS connectors - Power management: 1 power management IC, 1 power consumption measurement device Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com>
16 lines
1.1 KiB
Plaintext
16 lines
1.1 KiB
Plaintext
/* Do Not remove First 2 lines, Makefile will modify these lines with proper board names */
|
|
board=atmel_at91sam9x25ek
|
|
board_name=atmel,at91sam9x25ek
|
|
bootargs=console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait rootfstype=ext4
|
|
bootargsd2=console=ttyS0,115200 earlyprintk root=/dev/mmcblk1p2 rw rootwait rootfstype=ext4
|
|
bootargsxx=console=ttyS0,115200 earlyprintk root=/dev/mmcblk0p2 rw rootwait rootfstype=ext4
|
|
bootcmd=run setloadaddr; run setbootargs; run fatload_mmc; bootm ${loadaddr}
|
|
bootdelay=1
|
|
fatload_mmc=if test ${board_name} = atmel,sama5d2-xplained || test ${board_name} = atmel,sama5d27-som1-ek || test ${board_name} = microchip,sama7g5ek; then fatload mmc 1:1 ${loadaddr} ${board}-fit.itb; else fatload mmc 0:1 ${loadaddr} ${board}-fit.itb; fi
|
|
setbootargs=if test ${board_name} = atmel,sama5d2-xplained || test ${board_name} = atmel,sama5d27-som1-ek || test ${board_name} = microchip,sama7g5ek; then setenv bootargs ${bootargsd2}; else setenv bootargs ${bootargsxx}; fi
|
|
setloadaddr=if test ${board_name} = microchip,sama7g5ek; then setenv loadaddr 0x63000000; else setenv loadaddr 0x21000000; fi
|
|
ethact=gmac0
|
|
stderr=serial
|
|
stdin=serial
|
|
stdout=serial
|