9a0155bc4f
Add Kernel 5.15 patches + config. This is currently only available for the generic subtarget, as it was exclusively tested with this target. Tested-on: Siemens WS-AP3610, Enterasys WS-AP3705i Signed-off-by: David Bauer <mail@david-bauer.net>
69 lines
2.3 KiB
Diff
69 lines
2.3 KiB
Diff
--- a/drivers/gpio/Kconfig
|
|
+++ b/drivers/gpio/Kconfig
|
|
@@ -353,6 +353,13 @@ config GPIO_IXP4XX
|
|
IXP4xx series of chips.
|
|
|
|
If unsure, say N.
|
|
+
|
|
+config GPIO_LATCH
|
|
+ tristate "MikroTik RouterBOARD GPIO latch support"
|
|
+ depends on ATH79
|
|
+ help
|
|
+ GPIO driver for latch on some MikroTik RouterBOARDs.
|
|
+
|
|
config GPIO_LOGICVC
|
|
tristate "Xylon LogiCVC GPIO support"
|
|
depends on MFD_SYSCON && OF
|
|
@@ -529,6 +536,10 @@ config GPIO_ROCKCHIP
|
|
help
|
|
Say yes here to support GPIO on Rockchip SoCs.
|
|
|
|
+config GPIO_RB91X_KEY
|
|
+ tristate "MikroTik RB91x board series reset key support"
|
|
+ depends on ATH79
|
|
+
|
|
config GPIO_SAMA5D2_PIOBU
|
|
tristate "SAMA5D2 PIOBU GPIO support"
|
|
depends on MFD_SYSCON
|
|
--- a/drivers/gpio/Makefile
|
|
+++ b/drivers/gpio/Makefile
|
|
@@ -75,6 +75,7 @@ obj-$(CONFIG_GPIO_IT87) += gpio-it87.o
|
|
obj-$(CONFIG_GPIO_IXP4XX) += gpio-ixp4xx.o
|
|
obj-$(CONFIG_GPIO_JANZ_TTL) += gpio-janz-ttl.o
|
|
obj-$(CONFIG_GPIO_KEMPLD) += gpio-kempld.o
|
|
+obj-$(CONFIG_GPIO_LATCH) += gpio-latch.o
|
|
obj-$(CONFIG_GPIO_LOGICVC) += gpio-logicvc.o
|
|
obj-$(CONFIG_GPIO_LOONGSON1) += gpio-loongson1.o
|
|
obj-$(CONFIG_GPIO_LOONGSON) += gpio-loongson.o
|
|
@@ -123,6 +124,7 @@ obj-$(CONFIG_GPIO_PMIC_EIC_SPRD) += gpio
|
|
obj-$(CONFIG_GPIO_PXA) += gpio-pxa.o
|
|
obj-$(CONFIG_GPIO_RASPBERRYPI_EXP) += gpio-raspberrypi-exp.o
|
|
obj-$(CONFIG_GPIO_RB4XX) += gpio-rb4xx.o
|
|
+obj-$(CONFIG_GPIO_RB91X_KEY) += gpio-rb91x-key.o
|
|
obj-$(CONFIG_GPIO_RC5T583) += gpio-rc5t583.o
|
|
obj-$(CONFIG_GPIO_RCAR) += gpio-rcar.o
|
|
obj-$(CONFIG_GPIO_RDA) += gpio-rda.o
|
|
--- a/drivers/mtd/nand/raw/Kconfig
|
|
+++ b/drivers/mtd/nand/raw/Kconfig
|
|
@@ -570,4 +570,10 @@ config MTD_NAND_RB4XX
|
|
Enables support for the NAND flash chip on Mikrotik Routerboard
|
|
RB4xx series.
|
|
|
|
+config MTD_NAND_RB91X
|
|
+ tristate "MikroTik RB91x NAND driver support"
|
|
+ depends on ATH79 && MTD_RAW_NAND
|
|
+ help
|
|
+ Enables support for the NAND flash chip on MikroTik RB91x series.
|
|
+
|
|
endif # MTD_RAW_NAND
|
|
--- a/drivers/mtd/nand/raw/Makefile
|
|
+++ b/drivers/mtd/nand/raw/Makefile
|
|
@@ -60,6 +60,7 @@ obj-$(CONFIG_MTD_NAND_ROCKCHIP) += rock
|
|
obj-$(CONFIG_MTD_NAND_PL35X) += pl35x-nand-controller.o
|
|
obj-$(CONFIG_MTD_NAND_AR934X) += ar934x_nand.o
|
|
obj-$(CONFIG_MTD_NAND_RB4XX) += nand_rb4xx.o
|
|
+obj-$(CONFIG_MTD_NAND_RB91X) += rb91x_nand.o
|
|
|
|
nand-objs := nand_base.o nand_legacy.o nand_bbt.o nand_timings.o nand_ids.o
|
|
nand-objs += nand_onfi.o
|