Felix Golatofski ee3a6adc6c ath79: add support for Comfast CF-EW71 v2 ... Specifications: Qualcomm/Atheros QCA9531 2x 10/100 Mbps Ethernet, with 48v PoE 2T2R 2.4 GHz, 802.11b/g/n 128MB RAM 16MB SPI Flash 4x LED (Always On Power, LAN, WAN, WLAN) Flashing instructions: The original firmware is based on OpenWrt, so flashing the sysupgrade image over the factory firmware is sufficient. The bootloader has a built-in recovery web-ui. This is the method I used to flash OpenWrt. You can get to the recovery web-ui by holding down the reset button for a few seconds (~5s) while pluggin in the router. The LEDs should start blinking fast and the router should be available on 192.168.1.1 for the recovery. Tested: Reset button, WAN LED, LAN LED, Power LED (always on, not much to test), WLAN LED, MAC addresses (same as factory firmware). Signed-off-by: Felix Golatofski <git@xdfr.de>		2024-04-14 19:20:06 +02:00
..
imagebuilder	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
linux	ath79: add support for Comfast CF-EW71 v2	2024-04-14 19:20:06 +02:00
llvm-bpf	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
sdk	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
toolchain	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
Config.in
Makefile	build: add $(STAGING_DIR) and $(BIN_DIR) preparation to target and package subdir compile dependencies	2024-03-03 23:13:59 +01:00